What Senfeng's brochures say
| Brochure | Control system as described |
|---|---|
| H4 (up to 20 kW, 60 mm) | SF-Mimir LS intelligent control system, SF-Nest nesting installed |
| 1530N | Bus-based CNC system with a 27.5-inch screen, not named |
| 1313N, 3015NP | Intelligent bus-based CNC system, not named |
| 1530G | A widely used CNC system, not named |
The H4 brochure lists SF-Mimir LS among Senfeng's core components of independent research, next to its SF-PowerPlus laser source and its own cutting head, and says Senfeng develops its own CNC systems. None of the brochures lists the file formats the control system reads.
Which Zorocut setting to use
| Software on your Senfeng's screen | Controller in Zorocut |
|---|---|
| SF-Mimir | Other |
| CypCut or CypCutE | CypCut |
| HypCut | Other |
| Any other name | Other |
The DXF is the same in every case. If your screen shows Bochu software, the import steps are on the CypCut and HypCut pages.
What Zorocut exports
One ASCII DXF per sheet, R2000 (or R12), in mm, with only LINE, ARC and CIRCLE on five layers — ZC_CUT, ZC_MARK, ZC_ENGRAVE, ZC_SHEET, ZC_LABEL — and the sheet's lower-left corner at 0,0. No splines, blocks or polylines, which gives an undocumented importer the least to misread.
Settings in Zorocut
- Machine tab: kind Fiber laser, your power in W, and the controller from the table above.
- Export profile DXF R2000; try R12 if the software refuses the file.
- Part labels and Sheet outline off on SF-Mimir, since its handling of text and extra layers is not documented.
- Open one sheet on the machine and check a part's size against the drawing before the first cut.
Not verified yet
- No Senfeng import has been done with a Zorocut file.
- SF-Mimir LS has no public manual we could open: its DXF import, layers and units are not documented.
- Which software the models without a named system run is not stated in Senfeng's brochures.
Frequently asked questions
Does a Senfeng run CypCut?
Senfeng's own brochures do not say so: the H4 names Senfeng's SF-Mimir LS, and the others name no software. If your screen shows CypCut, set Controller CypCut and follow the CypCut page.
Do I need SF-Nest if I use Zorocut?
No. Either one nests the sheet. SF-Nest runs inside SF-Mimir on the machine; Zorocut nests and prices the job in the office and hands the controller a finished DXF per sheet.
Is Zorocut affiliated with Senfeng?
No. SF-Mimir and SF-Nest are Senfeng products; the names are used here only to describe compatibility.
Sources
Product names are used only to describe compatibility. Zorocut is not affiliated with their makers.
